STOPL-S-F1 for PE pipeline

STOPL-S-F1 for PE pipeline

Device STOPL-S-F1 is used for a medium temporary disconnection in pipeline with internal overpressure (or without overpressure) without a medium leakage. Device works on the following principle: stoppling head with a seal is inserted in pipeline through a bored hole, then it is  shifed outside of a bored hole and subsequently compress the sealing in a way that all pipeline section is sealed and it generates a medium flow interruption. A device connection to the pipeline is made through special shaped piece - perpendicularly to the axis of pipeline. 

Technical parameters:
Material and diameter of a sealed steel pipeline DN150-DN400
Pipeline: PE pipeline dn225 (SDR11 a SDR17), dn 315 (SDR11 a SDR17)
Medium: natural gas, non agressive gas, other medium after consultation with a producer.
Maximum overpresure in a sealed pipeline: up to 8 bar (0,8MPa)
Working temperature: -10/+50°C
STOPL –S-F1 (For inner diameters of steel pipeline 150mm a 400mm , a pressure up to 8 bar)  Newly 500 mm! IN A DEVELOPMENT !
STOPL-S-F1 (For outer diameters of PE pipeline 225mm and 315mm, a pressure up to 8 bar)

Thank You! Your message was successfully sent.
Sorry! Your message could not be sent.

Comments 0