STOPL-T-F1 for steel pipelines

STOPL-T-F1 for steel pipelines

Device STOPL-T-F1 is used for a temporary medium flow cut-off in the steel pipeline with  inner overpressure without a medium leakage. The device works on the following principle: through a bored hole the stopl cylinder is inserted into pipeline and in a bored hole it is mechanically pushed down until  medium flow cut-off.

  • Quick and simple assembling
  • Low weight
  • System of framed structure
  • DN65-DN100 tapped hole version
  • Pin slide caliper
  • Bypass simple solution

Material and diameter of  cut-off pipeline: steel  pipeline DN65-DN150
Medium: natural gas, non-aggressive gas, other medium after consultation with a producer
Maximum overpressure in cut-off pipeline: up to 10 bar (1,0MPa)
Working temperature: /10/+50 °C

Device STOPL-T-F1 (for pipelines  with inner diameters 65-150 mm, pressure up to 10bar)

Thank You! Your message was successfully sent.
Sorry! Your message could not be sent.

Comments 0